Radio Controlled Rocket Glider Kits
Ikarus Rocket Glider Kit
The Ikarus is a futuristic high speed reconaisance plane. It has a high mounted delta wing with a light wing loading giving it a very nice glide and easy/stable boost. It comes with a plastic nose cone and bt-80 tubing for the body and depron wing and tail surfaces. Construction is very simple and takes about an hour. You will need two 10 gram type servo, two 18-24" servo extensions, a receiver, and a small 250-500mah single cell lipo battery. You will need a transmitter with delta or elevon mixing. Both versions are identical in construction and flight, just the shape of the tail/wingtips are different. The recon version shown used the same markings as the IntR/Ceptor kit from stickershock23.
Please refer to the notes on items needed for completion and flying, then read the instructions completely before starting assembly. The assembly photos are for general reference but may not include every step in the manual.
CG location for rocket flight 14 5/8" forward from the TE of the wing
(Due to the CG location, and the fact that the equipment is mounted inside a body tube with no cooling airflow, it would be difficult to attach a battery and speed control in an optimum/accessable location, so it is not recommended to fly this using the electric adapter)
Welcome to the world of rocket boosted radio control gliders. This is not a model for a novice RC pilot, but anyone who is comfortable with RC flying of a medium speed model should be fine. Read through the instructions, look at the photos and be sure you understand the step before commiting to cutting or glue.
Ikarus Rocket glider instructions
Identify all pieces, the kit should contain:
1 wing taped together
2 wing spars(carbon fiber)
3 Vertical Stabilizers
2 Foam wing reinforcing strips
2 foam motor mount reinforcing strips
2 Body Tubes
Velcro(for battery and rx/bec attachment)
2 Rail buttons or 1 Launch lug
3M blenderm tape
Electric motor adapter
Notes before starting:
Reference to CA+ means foam safe CA+, normal CA+ will melt the foam! Normally you need to use accelerator to get the CA to set on the foam since there is nothing for it to soak into and activate.
You may use 220-320 grit sandpaper and a sanding block to slightly round the edges of the foam if you prefer that look. It will not markedly impact the flight performance either way. Be very careful and use a light touch, it is very easy to catch the foam on the edge of the paper and tear the foam. Do any sanding before assembly.
Epoxy is not needed in this model. Weight is critical and the model is designed for the thrust and flight loads. Weight in the rear end is bad and will require additional weight in the front of the model.
The basic construction is now complete.
Note: Your radio needs to be configured for Delta mixing, this means that the servo arms will move the same direction during elevator stick movement and opposite for aileron stick movement. Connect your servos to the receiver one in the aileron connection and one on the elevator connection and apply power. Use a servo arm at least 9/16” long and with holes small enough that there won’t be slop with the pushrod wire when installed. I use the hole furthest out on the servo arm, to maximize movement. On some servos there are a long two-ended servo arm, you can trim off one end if needed to get sufficient length. Zero out any trim settings on the transmitter. The model once the motor has burned out is nose heavy and flying wings lose pitch authority when nose heavy so you want as much up elevator travel for trim/flare as possible.
Flying: See the Instruction/Information link at the top for flying instructions Be ready on the first few flights to keep the model straight till you have the trims set perfectly for boost and glide.